All reports
Low

kernel: USB: serial: digi_acceleport: fix hard lockup on disconnect

Affected versions

Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported

Exploitation

CVE-2026-64334

Probability of exploitation in the next 30 days: 0.10%

FIRST EPSS · 2026-11-18

Description

In the Linux kernel, the following vulnerability has been resolved: USB: serial: digi_acceleport: fix hard lockup on disconnect If submitting the OOB write urb fails persistently (e.g if the device is being disconnected) the driver would loop indefinitely with interrupts disabled. Check for urb submission errors when sending OOB commands to avoid hanging if, for example, open(), set_termios() or close() races with a physical disconnect. This is issue was flagged by Sashiko when reviewing an unrelated change to the driver.

A flaw was found in the Linux kernel's digi_acceleport USB serial driver. This vulnerability occurs when a USB device using the driver is disconnected, and operations such as opening or closing the device are happening concurrently. Persistent errors in sending out-of-band (OOB) write Universal Serial Bus Request Blocks (URBs) can cause the driver to enter an indefinite loop with interrupts disabled. This leads to a system hard lockup, resulting in a Denial of Service (DoS).