All reports
Medium

kernel: USB: serial: option: fix slab OOB read in interrupt URB callback

Affected versions

Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported
Affected versions
Unknown
Fixed version
Not reported

Exploitation

CVE-2026-80827

Probability of exploitation in the next 30 days: 0.20%

FIRST EPSS · 2026-11-19

Description

In the Linux kernel, the following vulnerability has been resolved: USB: serial: option: fix slab OOB read in interrupt URB callback The interrupt URB buffer is allocated in setup_port_interrupt_in() based on the endpoint's wMaxPacketSize: buffer_size = usb_endpoint_maxp(epd); port->interrupt_in_buffer = kmalloc(buffer_size, GFP_KERNEL); When a USB device declares wMaxPacketSize = 8 on its interrupt IN endpoint, the buffer is allocated from kmalloc-8 cache (exactly 8 bytes). If the device sends a short packet (actual_length < wMaxPacketSize), the URB completes with status == 0 and the callback proceeds to read: data[sizeof(struct usb_ctrlrequest)] which evaluates to data[8], accessing 1 byte beyond the allocated 8-byte buffer. This results in a slab out-of-bounds read. Fix this by adding the missing bounds check: first verify that the actual length is large enough to contain the struct usb_ctrlrequest header before accessing req_pkt->bRequestType and req_pkt->bRequest, and then verify that there is an additional byte for the modem signal state before reading data[sizeof(struct usb_ctrlrequest)] inside the conditional. Use sizeof(*req_pkt) instead of sizeof(struct usb_ctrlrequest) for consistency. [ johan: use dev_err(); split signals declaration and initialisation ]

A flaw was found in the Linux kernel's USB serial option driver. A malicious USB device could exploit this vulnerability by sending a specially crafted short data packet. This could lead to an out-of-bounds read in memory, potentially allowing an attacker to access sensitive information or cause a denial of service.