همهٔ گزارش‌ها
متوسط

kernel: bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch()

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2026-98644

احتمال بهره‌برداری در ۳۰ روز آینده: 0.21%

FIRST EPSS · ۱۴۰۵/۰۸/۲۷

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch() __htab_map_lookup_and_delete_batch() has no rescheduling point. The batch count bounds how many entries are copied out, not how many buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the map end to end. The empty-bucket fast path is worse: it stays inside a single rcu_read_lock() / bpf_disable_instrumentation() section for any run of consecutive empty buckets. That holds up on small maps, but it falls apart at scale. On a 144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic BPF_MAP_LOOKUP_BATCH calls against an LRU hash map with 16,777,216 buckets held a CPU inside the batch op for 77+ seconds and triggered the soft lockup watchdog. Commit 75134f16e7dd ("bpf: Add schedule points in batch ops") fixed this same problem in the generic batch ops, but not in this htab-native path, which every htab-based hash map variant uses for its lookup[_and_delete] batch ops. Complete that fix here. Leave the critical section after 64 consecutive empty buckets, call cond_resched_tasks_rcu_qs(), and resume at the saved bucket cursor. No locks are held at that point, and resuming from the cursor is already the function's behavior for non-empty buckets. Add the same call to the per-bucket loop after copy_to_user(), where every lock has been dropped. cond_resched_rcu() is not enough here: sleeping with bpf_prog_active elevated makes tracing programs on that CPU silently skip their invocations. Plain cond_resched() is not enough either. It is a no-op under PREEMPT and PREEMPT_LAZY, the only models arm64 and x86 have offered since commit 7dadeaa6e851 ("sched: Further restrict the preemption modes"). It is also never a Tasks RCU quiescent state, in any model: the reschedule counts as a preemption. The walking task stays a holdout and stalls every synchronize_rcu_tasks() caller, ftrace and BPF trampoline teardown included, until the syscall returns [1]. cond_resched_tasks_rcu_qs() is the usual tool for that [2]. It reports the quiescent state at each yield and still reschedules as cond_resched() does on PREEMPT_NONE and PREEMPT_VOLUNTARY kernels.

A flaw was found in the Linux kernel's Berkeley Packet Filter (BPF) subsystem. A local user could cause a Denial of Service (DoS) by executing batch lookup or deletion operations on large hash maps. Due to a missing rescheduling check when traversing consecutive empty hash table entries, the kernel can monopolize the processor for prolonged periods without yielding. This issue triggers a soft lockup condition, resulting in system unresponsiveness.