همهٔ گزارش‌ها
متوسط

grub2: grub2: Secure Boot lockdown bypass via improper serial address validation

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2026-97876

احتمال بهره‌برداری در ۳۰ روز آینده: 0.12%

FIRST EPSS · ۱۴۰۵/۰۸/۲۸

شرح آسیب‌پذیری

A local attacker with control over GRUB's configuration can bypass lockdown restrictions when booting with Secure Boot and load an unsigned GRUB module, while GRUB continues to report lockdown is enabled. The vulnerability is caused by insufficient validation of the MMIO base address passed to the GRUB serial command. GRUB does not validate that the base address corresponds to a UART device, rather than being an arbitrary memory address. This allows an attacker to trick GRUB into writing non-arbitrary data at an attacker-controlled address, including resetting the grub_file_verifiers list in a way that disables the subsequent verification of loaded modules.

A flaw was found in GRUB2. The bootloader insufficiently validates memory addresses passed to the serial configuration command, allowing arbitrary system memory to be targeted instead of a legitimate serial communication device. A local attacker with control over GRUB's boot configuration can exploit this issue to overwrite internal verification structures. This vulnerability allows the attacker to bypass Secure Boot lockdown restrictions and load arbitrary unsigned modules during system boot.