همهٔ گزارش‌ها
متوسط

kernel: can: bcm: fix stale rx/tx ops after device removal

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2026-72116

احتمال بهره‌برداری در ۳۰ روز آینده: 0.19%

FIRST EPSS · ۱۴۰۵/۰۸/۲۸

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: can: bcm: fix stale rx/tx ops after device removal RX: an RX_SETUP update(!) for an existing op skipped can_rx_register() unconditionally, even when a concurrent NETDEV_UNREGISTER had already torn down its registration (op->rx_reg_dev == NULL). This silently did not re-enable frame delivery for that updated filter. bcm_rx_setup() now re-registers in that case, while leaving rx_ops with ifindex = 0 (all CAN devices) which never carry a tracked rx_reg_dev registered as-is. TX: bcm_notify() only handled bo->rx_ops on NETDEV_UNREGISTER, leaving tx_ops with an active cyclic transmission re-arming its hrtimer indefinitely to execute bcm_tx_timeout_handler(). Cancelling the hrtimer prevents the runaway timer and any injection into a later reused ifindex, since nothing else calls bcm_can_tx() for the op until an explicit TX_SETUP update re-arms it. Unlike bcm_rx_unreg(), which clears the tracked rx_reg_dev for rx_ops, the ifindex is intentionally left unchanged for tx_ops. bcm_tx_setup() always rejects ifindex 0, so clearing it would strand the op: neither a later TX_SETUP (bcm_find_op()) nor TX_DELETE (bcm_delete_tx_op()) could ever find it again, since both require an exact ifindex match.

A flaw was found in the Linux kernel's Broadcom Controller Area Network (CAN) bus driver. When a CAN device is removed, the driver may fail to properly manage its receive and transmit operations. This can lead to receive filters not being correctly re-enabled after updates, preventing expected data processing. Additionally, transmit timers might continue to run indefinitely, potentially causing system instability due to resource exhaustion or unintended data injection into a re-used network interface.