نسخههای متأثر
- نسخههای متأثر
- نامشخص
- نسخهٔ اصلاحشده
- اعلام نشده
بهرهبرداری
شرح آسیبپذیری
In the Linux kernel, the following vulnerability has been resolved: scsi: pm80xx: Fix array-index-out-of-of-bounds on rmmod Since commit f7b705c238d1 ("scsi: pm80xx: Set phy_attached to zero when device is gone") UBSAN reports: UBSAN: array-index-out-of-bounds in drivers/scsi/pm8001/pm8001_sas.c:786:17 index 28 is out of range for type 'pm8001_phy [16]' on rmmod when using an expander. For a direct attached device, attached_phy contains the local phy id. For a device behind an expander, attached_phy contains the remote phy id, not the local phy id. I.e. while pm8001_ha will have pm8001_ha->chip->n_phy local phys, for a device behind an expander, attached_phy can be much larger than pm8001_ha->chip->n_phy (depending on the amount of phys of the expander). E.g. on my system pm8001_ha has 8 phys with phy ids 0-7. One of the ports has an expander connected. The expander has 31 phys with phy ids 0-30. The pm8001_ha->phy array only contains the phys of the HBA. It does not contain the phys of the expander. Thus, it is wrong to use attached_phy to index the pm8001_ha->phy array for a device behind an expander. Thus, we can only clear phy_attached for devices that are directly attached.
A flaw was found in the Linux kernel’s pm8001_sas driver (SCSI: pm80xx). When unloading (rmmod) a device behind an expander, the code uses attached_phy (which may refer to a remote phy id) to index into the pm8001_ha->phy array, but the array only has entries for local phys. This out-of-bounds indexing is reported by UBSAN, which may lead to undefined behavior.

