همهٔ گزارش‌ها
متوسط

kernel: usb: dwc3: clear forceRM when issuing EndTransfer

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2026-90030

احتمال بهره‌برداری در ۳۰ روز آینده: 0.16%

FIRST EPSS · ۱۴۰۵/۰۸/۲۹

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: usb: dwc3: clear forceRM when issuing EndTransfer The forceRM bit of the DEPCMD register controls the behavior of the EndTransfer command used to stop an active transfer. Older DWC3 programming guide revisions recommended setting forceRM=1 when issuing EndTransfer. Newer programming guide revisions recommend issuing EndTransfer with forceRM cleared. With forceRM=1 on DWC_usb31 v2.00a and v2.10a controllers, a transfer aborted through the ep_dequeue path was observed to remain active after EndTransfer completion. A subsequent StartTransfer issued on the same endpoint triggered writes associated with the aborted transfer. This resulted in an SMMU fault because the transfer buffer had already been unmapped during EndTransfer command-completion cleanup. Using forceRM=0 eliminates the issue. Although older DWC3 programming guide revisions recommended setting forceRM=1, no issues are known from using forceRM=0. Clear forceRM when issuing EndTransfer to provide consistent EndTransfer behavior and align with newer programming guide recommendations.

A flaw was found in the Linux kernel's DWC3 USB controller driver. When the forceRM bit is incorrectly set during an EndTransfer command, a transfer may remain active even after completion. A subsequent StartTransfer on the same endpoint can then trigger writes to an unmapped memory buffer, leading to a System Memory Management Unit (SMMU) fault. This issue can result in system instability or a denial of service.