همهٔ گزارش‌ها
متوسط

kernel: scsi: qla2xxx: Skip NVMe LS reject IOCB when FW not started

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2026-89842

احتمال بهره‌برداری در ۳۰ روز آینده: 0.21%

FIRST EPSS · ۱۴۰۵/۰۸/۲۸

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: scsi: qla2xxx: Skip NVMe LS reject IOCB when FW not started qla_nvme_xmt_ls_rsp() bails out to the out: label when firmware is not started (!ha->flags.fw_started), but the out: path unconditionally calls qla_nvme_ls_reject_iocb(), which ends in qla2x00_start_iocbs() and an unconditional doorbell write to the request queue in-pointer register. This rings the firmware doorbell and queues an IOCB that stopped or resetting firmware cannot consume, and touches MMIO during the reset/EEH window where fw_started is also clear. Only emit the LS reject IOCB (and ring the doorbell) when fw_started is set; otherwise just clean up and return. The post-allocation failure cases (SRB alloc / qla2x00_start_sp() failure) run with firmware started and still send the reject. Apply the same guard to the reject emission in qla2xxx_process_purls_pkt().

A flaw was found in the Linux kernel's qla2xxx SCSI driver. Under certain conditions, specifically when the firmware is not fully initialized or is in a reset state, the driver attempts to communicate with it. This can cause the system to try and process an invalid command, leading to instability or a system crash. This issue could result in a denial of service.