همهٔ گزارش‌ها
متوسط

kernel: kernel: Denial of service via retried DSP firmware load in ALSA usx2y driver

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: ALSA: usx2y: Refuse a retried DSP load after a failure snd_usx2y_hwdep_dsp_load() sets up the asynchronous sequence URBs and the interrupt URB when the FPGA firmware image with index 1 is loaded, and then creates the ALSA devices. If usx2y_in04_init() or usx2y_create_alsa_devices() fails, the URBs that were already set up are left in place. The core keeps the index unloaded when the callback fails, so user space may issue the same request again. The second attempt then enters usx2y_async_seq04_init() or usx2y_in04_init() with the URBs still allocated and trips WARN_ON(usx2y->as04.buffer) or WARN_ON(usx2y->in04_urb). The URBs cannot be released at this point: the card may already have registered PCM devices that user space can still open, and the disconnect handler accesses the URBs without holding the DSP lock. Mark the chip as hung instead, so that a retried request is refused with -ENODEV and the assertions keep their meaning. The URBs are released by snd_usx2y_card_private_free() when the card is freed. A failing usx2y_async_seq04_init() still releases its own URBs, so that path remains retryable.

A flaw was found in the Linux kernel's ALSA (Advanced Linux Sound Architecture) usx2y audio driver. When an initial digital signal processor (DSP) firmware load fails, the driver leaves allocated USB transfer buffers active without properly resetting device state. A local user can trigger this flaw by re-attempting the failed firmware load request, which causes the driver to hit kernel warning assertions. This issue can lead to a denial of service (DoS) or system instability.