همهٔ گزارش‌ها
کم

kernel: tracepoint: balance regfunc() on func_add() failure in tracepoint_add_func()

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده
نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2026-46196

احتمال بهره‌برداری در ۳۰ روز آینده: 0.13%

FIRST EPSS · ۱۴۰۵/۰۸/۲۷

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: tracepoint: balance regfunc() on func_add() failure in tracepoint_add_func() When a tracepoint goes through the 0 -> 1 transition, tracepoint_add_func() invokes the subsystem's ext->regfunc() before attempting to install the new probe via func_add(). If func_add() then fails (for example, when allocate_probes() cannot allocate a new probe array under memory pressure and returns -ENOMEM), the function returns the error without calling the matching ext->unregfunc(), leaving the side effects of regfunc() behind with no installed probe to justify them. For syscall tracepoints this is particularly unpleasant: syscall_regfunc() bumps sys_tracepoint_refcount and sets SYSCALL_TRACEPOINT on every task. After a leaked failure, the refcount is stuck at a non-zero value with no consumer, and every task continues paying the syscall trace entry/exit overhead until reboot. Other subsystems providing regfunc()/unregfunc() pairs exhibit similarly scoped persistent state. Mirror the existing 1 -> 0 cleanup and call ext->unregfunc() in the func_add() error path, gated on the same condition used there so the unwind is symmetric with the registration.

A flaw was found in the Linux kernel. When a tracepoint (a mechanism for dynamic instrumentation) is registered, a failure during the probe installation process can lead to the registration's side effects persisting without a corresponding probe. This can cause a Denial of Service (DoS) by leaving system resources in an inconsistent state, specifically by increasing syscall trace entry/exit overhead for all tasks until the system is rebooted.