نسخههای متأثر
- نسخههای متأثر
- نامشخص
- نسخهٔ اصلاحشده
- اعلام نشده
- نسخههای متأثر
- نامشخص
- نسخهٔ اصلاحشده
- اعلام نشده
بهرهبرداری
شرح آسیبپذیری
In the Linux kernel, the following vulnerability has been resolved: team: Move team device type change at the end of team_port_add Attempting to add a port device that is already up will expectedly fail, but not before modifying the team device header_ops. In the case of the syzbot reproducer the gre0 device is already in state UP when it attempts to add it as a port device of team0, this fails but before that header_ops->create of team0 is changed from eth_header to ipgre_header in the call to team_dev_type_check_change. Later when we end up in ipgre_header() struct ip_tunnel* points to nonsense as the private data of the device still holds a struct team. Example sequence of iproute2 commands to reproduce the hang/BUG(): ip link add dev team0 type team ip link add dev gre0 type gre ip link set dev gre0 up ip link set dev gre0 master team0 ip link set dev team0 up ping -I team0 1.1.1.1 Move team_dev_type_check_change down where all other checks have passed as it changes the dev type with no way to restore it in case one of the checks that follow it fail. Also make sure to preserve the origial mtu assignment:
If port_dev is not the same type as dev, dev takes mtu from port_dev
If port_dev is the same type as dev, port_dev takes mtu from dev This is done by adding a conditional before the call to dev_set_mtu to prevent it from assigning port_dev->mtu = dev->mtu and instead letting team_dev_type_check_change assign dev->mtu = port_dev->mtu. The conditional is needed because the patch moves the call to team_dev_type_check_change past dev_set_mtu. Testing:
team device driver in-tree selftests
Add/remove various devices as slaves of team device
syzbot
A flaw was found in the Linux kernel's network team driver. A local user with network administration privileges can trigger this flaw by attempting to add an already active network device to a team interface. Because the driver modifies internal configuration settings before completing validation checks, the failed addition leaves the interface in an inconsistent state. Subsequent network traffic sent through the interface can cause the kernel to crash or hang, resulting in a Denial of Service (DoS).

