همهٔ گزارش‌ها
متوسط

kernel: PCI: tegra194: Move controller cleanups to pex_ep_event_pex_rst_deassert()

متن اصلی

نسخه‌های متأثر

نسخه‌های متأثر
نامشخص
نسخهٔ اصلاح‌شده
اعلام نشده

بهره‌برداری

CVE-2024-53152

احتمال بهره‌برداری در ۳۰ روز آینده: 0.28%

FIRST EPSS · ۱۴۰۵/۰۸/۲۷

شرح آسیب‌پذیری

In the Linux kernel, the following vulnerability has been resolved: PCI: tegra194: Move controller cleanups to pex_ep_event_pex_rst_deassert() Currently, the endpoint cleanup function dw_pcie_ep_cleanup() and EPF deinit notify function pci_epc_deinit_notify() are called during the execution of pex_ep_event_pex_rst_assert() i.e., when the host has asserted PERST#. But quickly after this step, refclk will also be disabled by the host. All of the tegra194 endpoint SoCs supported as of now depend on the refclk from the host for keeping the controller operational. Due to this limitation, any access to the hardware registers in the absence of refclk will result in a whole endpoint crash. Unfortunately, most of the controller cleanups require accessing the hardware registers (like eDMA cleanup performed in dw_pcie_ep_cleanup(), etc...). So these cleanup functions can cause the crash in the endpoint SoC once host asserts PERST#. One way to address this issue is by generating the refclk in the endpoint itself and not depending on the host. But that is not always possible as some of the endpoint designs do require the endpoint to consume refclk from the host. Thus, fix this crash by moving the controller cleanups to the start of the pex_ep_event_pex_rst_deassert() function. This function is called whenever the host has deasserted PERST# and it is guaranteed that the refclk would be active at this point. So at the start of this function (after enabling resources) the controller cleanup can be performed. Once finished, rest of the code execution for PERST# deassert can continue as usual.

A flaw was found in the Linux kernel's PCIe Tegra194 controller driver, which can lead to a Denial of Service (DoS). When operating in endpoint mode, the driver executes cleanup routines that access hardware registers after the connected host asserts a reset signal and disables the reference clock. Because the endpoint device relies on this host clock to remain operational, accessing registers without an active clock causes the system to crash.